American access system ADV-1000 Betriebsanweisung PDF herunterladen (Seite 414)

100

101

414 WIN-PAK User Guide

1 The Name list displays all 16 output points

available on the board, and shows them as active

[with the check box selected], with No ADV.

There can be a total of 16 output points on the

board (1-16). Remember, any output point you

intend to use will require an ADV.

2 Use the Time Zone drop-down list to attach a

time zone to an output point. For example: to

energize [activate] an output point during a

particular time zone, select that time zone from

the list. The Time Zone defaults to None.

3 Enter a value in the Pulse Time field to set the

amount of time that the output point is activated

[pulsed on] when triggered. The field defaults to

zero, but can be set from 0 to 32400 seconds, 0

to 540 minutes, 0 to 9 hours.

4 The Output Inverter field [which defaults to

Normal] can be changed to Inverted.

Following is a list of Output Inverter field settings.

Output Settings

NormalNormal

Normal

• Relay defaults to a de-energized state.

• Pulsing the output energizes it for its designated pulse time (or pulses the

output on). At the end of the pulse time, the output de-energizes. (The

output responds the same upon a valid egress, a valid card read, and/or a

manual pulse command.

• Energizing a relay turns the relay on (LED on).

• De-energizing a relay turns the relay off (LED off).

• Normally Open circuit acts as a NO circuit. Normally Closed circuit acts as a

NC circuit.

1 2 ... 409 410 411 412 413 414 415 416 417 418 419 ... 776 777

Kommentare zu diesen Handbüchern

Keine Kommentare

American access system ADV-1000 Betriebsanweisung Seite 414

Kommentare zu diesen Handbüchern