American access system ADV-1000 Betriebsanweisung PDF herunterladen (Seite 385)

100

101

385

11 The Delay field is only active if one of the

Timed options is selected as the Processing

Mode. The default for Reader, Card, or Panel

Based Timed APB is zero seconds. This time can

be set from zero to 32,767 seconds.

12 The Card Formats available are dependent upon

which cards were configured for the Intelligent

Controller [on the Card Format tabs]. Up to eight

card formats can be selected for each reader.

13 Control Flags are special options that can be set

for the reader, and include:

Control Flags and Results

Set to deny a duress request

Works in a card and PIN mode only. Unless this option is

selected, duress is always enabled. Notify the monitoring

station you are under duress. Always one number higher

than the PIN code.

Log all access requests as used

If selected, logs all card reads as "door used," without

actually determining if the door is used. If unchecked,

logs all card reads, but waits until the door times out, or

the door is opened, to report. Deselect this option when

using anti-passback.

Do not pulse the door strike on rex

Door strike does not pulse upon free egress, however door

contact still gets shunted.

Filter CosDoor transaction

Throughout the door cycle the IC generates about 4 to 5

messages (door strike relay on, door strike relay off, door

opening, etc.). If more message are needed, this feature

can be disabled.

Require two-card control at this reader

Needs 2 valid cards within a 20 second window to grant

access. Used in vaults, high security areas.

Programming

1 2 ... 380 381 382 383 384 385 386 387 388 389 390 ... 776 777

Kommentare zu diesen Handbüchern

Keine Kommentare

American access system ADV-1000 Betriebsanweisung Seite 385

Kommentare zu diesen Handbüchern