American access system ADV-1000 Bedienerhandbuch PDF herunterladen (Seite 7)

ACCESS & FUNCTION CODES

Depending on which model you have, your unit may be programmed with multiple (4 digit) access codes, the number of

access codes is reflected in the model number (eg. ADV-15(i) = 15 access codes). There are two different types of codes,

access codes & function codes. Although the number of access codes will vary with each model, the number of function

codes is always 3.

FUNCTION CODES

"MASTER CODE" This code is a programmable four digit code

used for gaining access to the program mode.

The factory default master code is 1 2 5 1.

"LATCH CODE" This code is a programmable four digit code

used to toggle relay A. This code will be used

to hold open a gate or door.

"SLEEP CODE" This code is a programmable four digit code

which when entered, will disable all codes.

When the "SLEEP CODE" is entered again the

unit will be enabled. An override code is provided.

GOODBEEPS & ERRORBEEPS

Your unit will beep each time a key is pressed. The "*" key serves as the clear key and a double beep will be heard when

this key is pressed. A "GOODBEEP" is represented by an oscillating high tone. An "ERROR BEEP" is represented by a

single low tone.

THE RED & YELLOW LED's

Two different colored LED's are in the face of the unit. The red LED will light during the duration of the relay(s)

activation period. The yellow LED will light while the unit is in the program mode. During memory erasure or setup the

LED's will flash.

RESETTING THE UNIT

Your unit provides 2 different types of resets, a Unit Reset, and a Master Reset.

A Master Reset should be utilized in the event that you lose or forget your master code or if the unit is in the Latch or

Sleep mode and the Latch or Sleep code is lost or forgotten. When a Unit Reset is performed, the master code will be set

back to 1 2 5 1.

A Unit Reset is provided should it ever become desirous to reset the unit back to the initial factory state. After a Master

Reset has been performed the unit will DELETE ALL ACCESS & FUNCTION CODES and the master code will be

set back to 1 2 5 1.

MASTER RESET

Follow these steps precisely. If you make an error, the unit will ERROR and you will have to start over.

⇒

Disconnect power from the unit by pulling the wire harness away from the board.

⇒

Reconnect power to the board while holding down the RESET button (See location diagram, pg. 11 ).

⇒

Release Reset button and enter

* * *

from the keypad.

The unit will issue a good beep and the master code will be set back to 1 2 5 1. If you previously were in the sleep or

latch mode, the unit will be brought back to idle state.

Page 6

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

American access system ADV-1000 Bedienerhandbuch Seite 7

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Ziffernblock American access system ADV-1000