American access system ADV-1000 Betriebsanweisung PDF herunterladen (Seite 8)

Speedway Reader IPJ-R1000 for Gen 2 UHF RFID

RJ-45

Ethernet Jack

DB-9 Serial

Port

DB-25

GPIO Port

Power Supply

Input

RP-TNC RF Antenna

Connectors

Status

LEDs

Mounting

Holes

Mounting

Holes

Figure 1-2 Impinj Speedway Reader Port Connections

1.3. Mounting the Speedway Reader

When securing the unit with #10 screws via the four mounting holes, the Speedway reader may be mounted horizontally or

vertically on a stable surface where it will be safe from disturbance. Keep the unit away from direct sunlight, high humidity,

extreme temperatures, vibration, and sources of electromagnetic interference, as any combination of these conditions may

degrade performance or shorten the life of the unit.

1.4. Connecting Power

Connect the AC power plug into a suitable 100-240 VAC, 50-60 Hz power outlet. The green Power LED will light when

power is on. The reader will then begin its boot sequence (note: normal boot time for the reader’s operating system is ~50

seconds). The reader cannot be commanded until the boot sequence is complete.

1.5. Connecting the Antenna(s)

The Speedway reader is equipped with four (4) independent, bidirectional, full duplex TX/RX ports (monostatic), which must

be cabled to their respective Impinj-approved antennas prior to power-up. Unused antenna ports must be left unconnected;

they should not be terminated.

Note: Reader power has been factory preset to 30 dBm to accommodate an antenna with up to 6 dBi composite gain (inclusive

of cabling). The Speedway reader may only be operated with Impinj-approved antennas and can radiate no more than 36 dBm

EIRP per FCC Part 15.247 regulations. To obtain the maximum allowable reader power setting, the following expression

should be used:

Maximum power setting (in dBm) = 36 – Antenna Gain (in dBi)

where the antenna gain includes the loss of the associated cable from the reader to the antenna.

Approved antenna vendors, model numbers, gain characteristics, and associated RF cable/connector include:

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 64 65

Keine Kommentare

American access system ADV-1000 Betriebsanweisung Seite 8